News

Faucet installation method

Update:29-10-2018
Summary:

First, prepare the installation tools. Check whether th […]

First, prepare the installation tools. Check whether the matching parts are complete before installation. Common faucet parts include: hoses, rubber washers, showers, water, kidnappers, decorative caps, etc.

1. Single hole basin faucet installation

When purchasing a single-handle basin faucet, you should pay attention to the diameter of the water outlet. Most of the market is filled with hard water, so you should pay attention to the height of the water inlet. The 35 working points from the basin are most suitable. When installing, be sure to choose a special angle valve, and the angle valve must be fixed with the hot and cold water pipe of the wall outlet. When you find a distance between the angle valve and the water pipe on the faucet, purchase a special extension tube to connect. Remember, don't use other water pipes to connect, because if the water pressure is too large, it will easily fall off and leak, causing damage to you. If the inlet pipe is too long to exceed the outlet pipe, you can cut off the part according to your needs. If the angle is not suitable, bend it to the position you need as needed. Remember: Do not bend hard to 90 degrees or more than 90 degrees. When installing the basin to remove water, please don't forget to buy the small interface of the faucet (the faucet is shorted). Don't forget to flush the water pipes buried in the wall before you install it.

2. Installation of shower and bathtub faucet (wall)

When you have purchased a shower, bathtub, or wall faucet, you can choose the right height to bury the water pipe. The spacing between the hot and cold water pipes must be 15 cm. Before installation, you must not forget to rinse the water pipe to avoid excessive water quality and damage to the faucet.

Concealed shower, bath faucet: After purchasing the concealed faucet, the sluice spool should be pre-buried in the wall. Be sure to pay attention to the thickness of the bathroom wall before embedding. If the wall is too thin, the spool will not be buried. The plastic protective cover of the valve plug should not be easily removed when it is buried, so as to prevent the cement and other chores from damaging the valve core when it is buried. In addition, when pre-burying the valve core, you should also pay attention to the up and down and left and right directions of the valve core to avoid the valve core being buried. When the wall mounted faucet is pre-buried into the water pipe, the size is deviated, and the adjustment can be used to adjust the position.

www.xinba-sanitaryware.com

  • 18yrs

    18 years experience in sanitaryware fitting industry

  • 30+

    Our products are sold to more than 30 countries and regions

  • 200+

    We have a large production team, R & D team

  • 30million

    Our factory has a total investment of more than 30 million.

  • 7000m2

    7000² square meters of factory area

  • 10+

    We have more than 10 patents for inventions